Baldor PC SEries Bedienerhandbuch PDF herunterladen (Seite 8)

1-4 General Information MN1240

Safety Notice Continued

Caution: To prevent premature equipment failure or damage, only qualified

maintenance personnel should perform maintenance.

Caution: Do not lift the motor and its driven load by the motor lifting hardware.

The motor lifting hardware is adequate for lifting only the motor.

Disconnect the load from the motor shaft before moving the motor.

Caution: To prevent equipment damage, be sure that the control is fused for the

maximum motor rated amps listed on the rating plate.

Caution: If a HI POT test (High Potential Insulation test) must be performed, follow

the precautions and procedure in NEMA MG-1 and MG-2 standards to

avoid equipment damage.

Caution: Do not perform dielectric withstand tests on any feedback device or

motor control as damage may result.

Caution: Motor housings get very hot during normal operation. Do not touch the

motor after use until it has had sufficient time to cool. Severe burns

may result from touching the motor after use.

Caution: Do not use the holding brake to stop motion. This will cause premature

brake wear and failure. The brakes are not designed to stop a rotating

load. The servo drive inputs should always be used to stop motor shaft

rotation.

Caution: The AC servo motor is not intended to be connected directly to the AC

mains. Do not connect AC Mains directly to BSM AC Servo Motors.

If you have any questions or are uncertain about any statement or procedure,

or if you require additional information please contact your Baldor distributor

or an Authorized Baldor Service Center.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Keine Kommentare

Baldor PC SEries Bedienerhandbuch Seite 8