Baldor PC SEries Bedienerhandbuch PDF herunterladen (Seite 18)

2-10 Installation MN1240

Strain Relief (Mounted at Terminal Box)

The motor cable is terminated at the Terminal Box using a Shielded Strain Relief

Connector. Figure 2-8 shows the components.

1. Strip the outer shield from the cable to expose the conductors and

shield.

2. Slip the Strain Relief components onto the cable in the order shown.

3. Fold the Shield wires over the end of the Contact Carrier.

4. Slide the Threaded Adapter onto the Contact Carrier until the Carrier is

completely inserted into the Adapter.

5. Slide the Gasket into the Contact Carrier.

6. Slide the Adapter Cover onto the Threaded Adapter and Tighten. As it is

tightened, it compresses the Gasket against the Cable to form the strain

relief and securely hold the cable.

7. The assembly can be inserted into the Terminal Box and secured.

Figure 2-8 Motor Cable Strain Relief Assembly

Threaded

Adapter

Gasket Adapter

Cover

Contact

Carrier

Shielded Cable

Assemble Parts onto Cable

Assembled

Fold Shield wires over Contact Carrier

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Baldor PC SEries Bedienerhandbuch Seite 18